Download the manual

The IP-1 IndustryPack module has 32 inputs/outputs arranged as 4 ports of 8 bits. Each port can be configured as a 0-60vdc input, or can drive a 60v load to ground. The IP-1 modules uses state of the art BGA packaging and TSSOP devices to make this one of the densest IP-modules ever made. True programmable hysteresis, interrupts on all channels, over-voltage protection and over-current protection make this a truly versatile board.

IP-1 Features

• High Density I/O - 32 Channels per module, 160 Channels per carrier.
• High Voltage - Can handle 60v inputs/outputs, internal circuitry to clamp inductive spikes to 90v max.
• High Current - Can drive 100ma on each channel. Internal circuitry can detect over-current situations and shut down the board.
• Programmable Hysteresis - On board DACS allow setting the set/reset thresholds on a per port basis from 0-60v. High Speed Outputs and input good through 2mhz.
• Programmable pullup/pulldown - Board can set a resistor bank to pullup/pulldown mode in software, solving power sequencing problems.
• Analog Input - Real voltages can be measured on each input channel. Can be used a a 32-Channel low-bandwidth oscilloscope.
• On board resistor-networks - No need to mount external pull-ups. Of course it is possible to remove the on board networks to make use of external ones.
• High input impedance - Standard input impedance of 240k ohms. Other values available upon request.
• Power on reset - All outputs are guaranteed to be high impedance while the board is powering on.
• Output read back - Inputs can be simultaneously enabled with the outputs to verify a state change.

• No wait states - All transfers to/from the IP-1 module require zero wait states, freeing bus bandwidth for other purposes.

• Customizable logic - Includes a 250k gate xilinx spartan-3e that can be used to implement custom logic.

• Interrupts - All channels can be set an interrupt source.

• SDK - Includes software development kit which demonstrates accessing the various features of the board. Out of the box support for acromag pci carriers. Code can easily be adapted to any system.

• Firmware upgrades - Updated firmware can be loaded over the IP-Bus interface.

   

Pry Mfg Co keeps these boards in stock. Orders that cannot be filled immediately have a 4-week lead time. Orders less than $5000 can be paid by credit card. Larger orders must be payed by check. Net terms available on approved credit. Volume discounts available. Contact us for details.